PCG007 310W PC power for HP

道場TOP ネタ一覧 batteryclub2019道場

PCG007 310W PC power for HP

◇評価 0ポイント; ◇閲覧回数 2,431回
◇登録日: 2019年9月24日

: batteryclub2019; 道場主

Lv.25

Maximum transmission power supply replacement - HP PCG007 pc power supply +12.0Vmain==16A +12Vcpu ==16A . PCG007 power supplies are compatible with HP ProDesk 280 288 G3 MT. Shopping PCG007 pc power online, more discount and money-saving. Check your HP output power and voltage(Ref 80Plus) before you order PCG007 pc PSU service. Cost-effective computer power supply charging replacement, please visit www.batteryclub.org for more information.

Brand : HP power supply
Input Voltage : 100-240V~,50-60Hz 4.0A 310W
Ouput Volatge : +12.0Vmain==16A +12Vcpu ==16A
Is there no power supply model you find? Take it easy! Contact us fast with your e-mail for what PC power models your are looking for.

Email: info@batteryclub.org

PCG007 replacement model：

PCG007 937516-004

Compatiblet with HP ProDesk 280 288 G3 MT:

MODEL: PCG007
PART NUMBER: 937516-004
AC INPUT: 100-240V~,50-60Hz 4.0A
DC OUTPUT: +12.0Vmain==16A +12Vcpu==16A
MAXNUM POWER SHALL NOT EXCEED 310W
power Size: 95*72*165mm
Power supply interface:
4+4 pin
1x flat 7 pin
3-wire interface
Compatible Models:
For
HP ProDesk 280 288 G3 MT
HP 400G4 282G3 SFF

https://www.batteryclub.org/Goods/HPQ17526_SE-PCG007-Hp-Adapter.html

How to maintain HP PCG007 computer power supply

1. Remove the fan. Disconnect the main power supply first, and unplug the input and output cables on the back of the power supply. Next, unplug and connect all the accessories connected to the power supply, remove the fixing screws of the power supply box, and take out the power supply box. Observe the appearance of the power supply box, remove the screws reasonably and accurately, and remove the cover. When taking the cover, the wires should be pulled out according to the gap at the same time. Remove the four screws that secure the fan and remove the fan. You can not solder the two power cables temporarily.
2. Clean the dust. After separating the power supply board and the fan with cardboard, use a small brush or a damp cloth to wipe the dust and wipe it clean. It is also possible to use dust from the fan to blow fan blades and bearings.
3. Add lubricant. Peel off the sticker and use a needle-nose pliers to pick out the rubber seal. Find the motor bearing, add lubricant, and when you use the fan to move the fan, make the lubricant flow evenly along the bearing, then add a few drops. Pay attention to whether the fan of the ball bearing has two bearings. Don't neglect the oil feeding to the bearing on the wind side. The oil can't be placed on the main shaft only. Lubricating oils must use computer-specific lubricants or advanced lightweight sewing machine oils. Never use the lubricants used in automobiles. Finally, install the rubber sealing sheet and label it.